Catalogue
Amplification switching device Twist 16DA1x2 is intended to gain and distribute composite video signals from 16 independent inputs into the two loads (16 active dividers 1x2).
There is compensation for losses in lines and input signal indicator for each channel. It can be mounted between the cable lines which transmit video signals, and input registration devices cascades (video servers, monitors, etc.). Due to minimal distortion, low noise and wide working frequency band it is recommended for use in the composition of professional television equipment and video surveillance systems.
| Operating Temperature Range | 0 to +50°С |
| Relative humidity | up to 90% |
| Video inputs number | 16 |
| Video outputs number | 32 |
| Input/output impedance | 75 Ohm |
| Nominal input/output voltage (75 Ohm) | 1.0 V |
| Frequency range | 5 Hz … 20 MHz |
| Gain control range | 0.3-1.8 |
| THD (without correction) in the working frequency range, dB, max | -50 |
| Channel separation at a frequency 6 MHz, dB, max | -60 |
| Power | ~220 V (±10%), 50 Hz |
| Power consumption | 12 |
| Dimensions | 483 х 89 х 46 mm |
| Warranty period | 36 months |
TWIST 16DA1x2 is collected in a metal casing for installation in 19" rack (2U unit height)
There are such controls and indicating on the front panel:
- power switch
- power led
- output signal gain control (divided by 32 channels)
- input video signal level indicator (16 channels)
- frequency correction jumpers (16 channels)
On the rear panel there are:
- BNC connectors for connecting the sources of input signals (16 channels)
- BNC connectors for connection the display and recording equipment (32 channels) connector for connecting power supply
| Length | Testing table | At the object | Oscillogram |
| 1000 m |  |
 |
 |
| 2000 m | |
|
|
 |
 |
 |
 |
 |
 |