TWIST

Equipment for transferring video over the twisted pair

Contact us

01033, Ukraine, Kyiv
Vasiliy Yan str., 3/5, 4 floor
Map

Phone: +380 44 498-61-80
Fax: +380 44 498-61-81
Email: info@twist.kiev.ua


Online ICQ support:

490-646-321 - Nina
307-593-042 - Elena
118-981-052 - Sergey

Catalogue

TWIST-PS12-1

Purposes

Switching power supply TWIST - PS12-1 is designed to power cameras, as well as various operating in long duration mode devices, which have higher supply voltage quality requirements.

Features

  • Low supply voltage pulsation
  • Protection against overload on the inputs and outputs, short circuit, overheating
  • LED indication of operating mode
  • Easy installation consisting of equipment

Operating conditions

Operating Temperature Range -10 to +50°С
Relative humidity up to 90%

Specification

Output Output DC voltage 12 V
Nominal current 1 A
Max current (*) 1.2 A
The output voltage pulses, between peaks (**) 30 mV
Total instability of the output voltage 5%
Efficiency 80%
Input Input AC voltage 120~250 V
Voltage frequency 47-63 Hz
Protection availability Input overvoltage (fuse) >275 V
Overheating yes
Overload output current (LED is flashing) > 1.35 A
Short circuit at the output (LED is off) yes
Recovering operating mode after the protection operation yes
Other Isolation voltage (input-output) > 3 kV
Isolation resistance (input-output) >20 MOhm
Dimensions 67 x 47 x 37 mm
Warranty period 36 months

* Working at the maximum current possible at the temperature ranging from -10 to +25°C
** Measured in the 60 MHz on the output cable connected to the capacitor 0.1 mkF

Installation and maintenance


Power supply is indoor mounted. It requires sealing case for outdoor installation. The source is connected to the 220V ~ 50Hz through distribution block. The output voltage connection polarity to the load is indicated on the case of the device. When power is connected the LED on the case will be active.

WARNING!
To increase the lifetime of the power source you must observe the temperature profile in the technical specifications. Above the upper temperature limit burst protection may turn on. This turns off the LED and turns off the output voltage. When you restore the normal temperature mode the power source will resume functioning automatically.


© 2005—2009 TWIST